A modified transformation of circulation road of slurry pump seal with conical sealing wearings based on CFD

CHEN Yawei; LIANG Shuangyin; ZHANG Xingwen; XIONG Xin; TONG Lianyao

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

A modified transformation of circulation road of slurry pump seal with conical sealing wearings based on CFD

更新时间：2025-09-28

- A modified transformation of circulation road of slurry pump seal with conical sealing wearings based on CFD
- Thermal Power Generation Vol. 43, Issue 11, Pages: 120-125(2014)
- 作者机构：
  
  华北电力大学能源动力与机械工程学院
- 作者简介：
- 基金信息：
- DOI：
  CLC： TM621
- Published：2014
- 稿件说明：
移动端阅览
CHEN Yawei, LIANG Shuangyin, ZHANG Xingwen, et al. A modified transformation of circulation road of slurry pump seal with conical sealing wearings based on CFD[J]. Thermal power generation, 2014, 43(11): 120-125.
DOI：

CHEN Yawei, LIANG Shuangyin, ZHANG Xingwen, et al. A modified transformation of circulation road of slurry pump seal with conical sealing wearings based on CFD[J]. Thermal power generation, 2014, 43(11): 120-125. DOI：

摘要

某电厂600 MW机组用KWPKC 600-800型离心式脱硫浆液循环泵为锥形密封口环

在运行过程中出现较为剧烈且规律性的振动

影响了脱硫系统的正常运行。为此

运用CFD分析法计算得出泵内两相流流场的速度分布及压力分布

并对叶轮口环进行了加装挡流平台和改变密封流道的改造。改造后

对口环间隙分别为3、6mm的泵内流场进行数值模拟。结果表明

改造后泄流对入口流道处所形成的高压屏障处压力有所减小

噪声、振动明显减弱。

Abstract

The 600-800 type centrifugal desulfurization slurry cycling pump in a 600 MW unit applies conical sealing rings

which had intense and regular vibrations during work

affecting normal operation of the desulfurization system.Therefore

the CFD software was adopted to simulate the velocity distribution and pressure distribution of the two-phase flow in the pumps.Moreover

the impeller wearing ring was retrofitted by installing a buffle plat.After the transformation

numerical simulation on flow field inside the pump was carried out

with the ring gap of 3mm and 6mm

respectively.The results show that

the vibration of the slurry pump operation reduced dramatically.

关键词

Keywords

references

Views

101

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Numerical simulation on low NOx combustion of pulverized coal by low temperature pre-combustion

Numerical modeling and optimal design of flow field for a wet electrostatic precipitator system

Research on main and reheat steam temperature lifting method for ultra supercritical 1 000 MW unit double-tangential circular boiler

Numerical simulation and practical verification of soot-blowing system retrofitting for tubular gas-gas heater

Numerical simulation of reverse-tangent and swirling-eliminationfor SOFA of boiler co-firing biomass gas with coal

Related Author

LIU Changchun

HUI Shien

DENG Jun

MA Xiuyuan

SHEN Zhiyong

LI Zhiqiang

ZHANG Xiaotao

HUANG Yong

Related Institution

College of Safety Science and Engineering, Xi’an University of Science and Technology

School of Energy and Power Engineering, Xi’an Jiaotong University

State Power Environmental Protection Research Institute

College of Electric Power, North China University of Water Resources and Electric Power

School of Electric Power, North China University of Water Resources and Electric Power

AI问答

⁰