Heat storage coefficient calculation for typical supercritical 660MW unit once-through boilers

LIAN Haiqing; TIAN Liang; DAI Yunfei

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Heat storage coefficient calculation for typical supercritical 660MW unit once-through boilers

更新时间：2025-09-28

- Heat storage coefficient calculation for typical supercritical 660MW unit once-through boilers
- Thermal Power Generation Vol. 44, Issue 5, Pages: 81-86(2015)
- 作者机构：
  
  1. 华北电力大学控制与计算机工程学院
  2. 宁夏京能宁东发电有限责任公司
- 作者简介：
- 基金信息：
- DOI：
  CLC： TM621.2
- Published：2015
- 稿件说明：
移动端阅览
LIAN Haiqing, TIAN Liang, DAI Yunfei. Heat storage coefficient calculation for typical supercritical 660MW unit once-through boilers[J]. Thermal power generation, 2015, 44(5): 81-86.
DOI：

LIAN Haiqing, TIAN Liang, DAI Yunfei. Heat storage coefficient calculation for typical supercritical 660MW unit once-through boilers[J]. Thermal power generation, 2015, 44(5): 81-86. DOI：

摘要

为满足协调控制系统对被控模型准确可靠性的要求

提出了一种通过锅炉设计数据计算蓄热系数的方法

该方法根据工质蓄热能力及有无相变将锅炉汽水系统划分为8个吸热段

分别计算出每段的汽水蓄热系数和金属蓄热系数

最后结合锅炉结构参数汇总计算得到锅炉总蓄热系数。实际应用结果表明:超临界660 MW机组直流锅炉蓄热系数约4 000 MJ/MPa;锅炉总蓄热系数中金属蓄热所占比例超过60%

大于汽水蓄热;直流锅炉的单位负荷蓄热系数随锅炉容量的增加呈减少趋势

汽包锅炉的单位负荷蓄热系数大于直流锅炉。

Abstract

To meet the demands of accuracy and reliability for controlled model of the coordinated control system

a method of calculating heat storage coefficient through boiler design data was proposed.In this method

the boiler steam-water system is divided into eight endothermic segments

according to heat storage ability and phase change of the working fluid.The steam-water heat storage coefficient and the heat storage coefficient of metallic material of each segment are calculated.Then

combining with the boiler design data

the total heat storage coefficient can be obtained.Finally

this method was applied on a supercritical 660 MW unit once-through boiler.The results show that

the heat storage coefficient of this boiler is about 4 000 MJ/MPa and the percentage of heat storage of metallic material is above 60%

which is larger than that of the steam-water heat storage.Compared with the data obtained

for once-through boiler

the heat storage coefficient per unit power load decreases with the increase of boiler capacity

and the heat storage coefficient per unit power load of drum boiler is higher than that of the once-through boiler.

关键词

Keywords

references

Views

286

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Numerical simulation on stress distribution in steam separator of a 600MW unit once-through boiler during cold start-up process

Optimization of load control strategy for a supercritical 600MW unit boiler

KINDS AND TECHNICAL FEATURES OF THE STARTING-UP SYSTEM FOR SUPERCRITICAL ONCE-THROUGH BOILERS

RETROFIT OF COORDINATED CONTROL SYSTEM FOR ONCE-THROUGH BOILER OF SUPERCRITICAL 600 MW UNIT AND APPLICATION OF AGC STRATEGY

ANALYSIS OF CONTROL-ORIENTED DYNAMIC BEHAVIOR FOR SUPERHEATED STEAM TEMPERATURE

Related Author

ZHANG Ying

QIU Yang

ZHOU Zhilei

MA Chunhong

YANG Ping

GAO Longjun

WANG Xiaogang

ZHANG Changqing

Related Institution

School of Mechanical and Electrical Engineering, Nanchang University

Sinopec International Petroleum Exploration and Development Co., Ltd

Huaneng Group Technology Innovation Center

Xi'an Thermal Power Research Institute Co., Ltd

School of Telecommunications, Xi'an Jiaotong University

AI问答

⁰