Numerical study on heat and mass transfer in channel of wavy fin-and-tube with declined wavy height
|更新时间:2025-09-28
|
Numerical study on heat and mass transfer in channel of wavy fin-and-tube with declined wavy height
Thermal Power GenerationVol. 44, Issue 11, Pages: 37-42(2015)
作者机构:
太原理工大学电气与动力工程学院
作者简介:
基金信息:
DOI:
CLC:TK172
Published:2015
稿件说明:
移动端阅览
WU Guangjian, YIN Jixiang, MA Jianzong. Numerical study on heat and mass transfer in channel of wavy fin-and-tube with declined wavy height[J]. Thermal power generation, 2015, 44(11): 37-42.
DOI:
WU Guangjian, YIN Jixiang, MA Jianzong. Numerical study on heat and mass transfer in channel of wavy fin-and-tube with declined wavy height[J]. Thermal power generation, 2015, 44(11): 37-42.DOI:
Numerical study on heat and mass transfer in channel of wavy fin-and-tube with declined wavy height
To obtain a fin tube heat exchanger which can both ensure the heat transfer effect and reduce the flow resistance as low as possible
the flow and heat transfer characteristics of wavy fin-and-tube and wavy fin with uniform declined wavy height was numerically simulated.The local average Nusselt number and pressure drop of wavy fin with different wavy heights
and the average Nusselt number and pressure drop of wavy fin with different wavy heights at different Renolds number were analyzed.The results show that the comprehensive heat transfer performance of wavy fin with uniform declined wavy height under identical pressure drop condition and identical pumping power condition are superior to that of the wavy fin with wavy height of 2.0mm.The wavy fin with uniform declined wavy height not only ensured well heat transfer performance but also decreased the pressure drop during flow.
Influence of roughness on heat transfer of pin-fin with lamilloy structure
Numerical simulation and structure optimization for inlet and outlet duct of electrostatic precipitator in a 1 000 MW unit
Flow characteristics of exhaust pipes in a 1 000 MW direct air-cooled unit
Research on main and reheat steam temperature lifting method for ultra supercritical 1 000 MW unit double-tangential circular boiler
Numerical simulation and practical verification of soot-blowing system retrofitting for tubular gas-gas heater
Related Author
LI Guangchao
JIANG Wei
LIU Yongquan
ZHANG Wei
KOU Zhihai
LI Wanwan
LIU Liping
JIA Yan
Related Institution
Liaoning Key Lab of Advanced Test and Measurement Technology for Aerospace Propulsion System, Faculty of Aerospace Engineering, Shenyang Aerospace University
Shenyang Engine Design Institute, Aviation Engine Corporation of
School of Power and Mechanical Engineering, Wuhan University
Department of Geography and Digital Technology,Wuhan University
Central Southern China Electric Power Design Institute,China Power Engineering Consulting Group Corporation