Optimization design of steam turbine with double-reheat in a 1 350MW ultra-supercritical unit

ZHANG Xiaoling; YAN Weiping; LIU Liheng; ZHU Yunfei

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Optimization design of steam turbine with double-reheat in a 1 350MW ultra-supercritical unit

更新时间：2025-09-28

- Optimization design of steam turbine with double-reheat in a 1 350MW ultra-supercritical unit
- Thermal Power Generation Vol. 45, Issue 1, Pages: 110-116(2016)
- 作者机构：
  
  1. 华北电力大学能源与动力机械工程学院
  2. 国电科学技术研究院
- 作者简介：
- 基金信息：
- DOI：
  CLC： TM621
- Published：2016
- 稿件说明：
移动端阅览
ZHANG Xiaoling, YAN Weiping, LIU Liheng, et al. Optimization design of steam turbine with double-reheat in a 1 350MW ultra-supercritical unit[J]. Thermal power generation, 2016, 45(1): 110-116.
DOI：

ZHANG Xiaoling, YAN Weiping, LIU Liheng, et al. Optimization design of steam turbine with double-reheat in a 1 350MW ultra-supercritical unit[J]. Thermal power generation, 2016, 45(1): 110-116. DOI：

摘要

为研究轴系布置和轴速对超超临界1 350 MW二次再热机组热效率和经济性的影响

构建了4种汽轮机型式的方案进行模拟和计算

分析了汽轮机排汽口数目、单双轴布置型式和轴速对机组经济性和热效率的影响。结果表明:对超超临界1 350 MW二次再热机组

宜优先选用4排汽

双轴

全、半速各一轴方案

厂净效率可达46.01%;其次可以考虑6排汽、单轴、全速方案;4排汽、单轴、全速方案和6排汽

双轴

全、半速各一轴方案皆因存在技术性限制或投资经济性劣势而不宜采纳。

Abstract

To investigate the influence of shaft arrangements and shaft speed on efficiency and economy of the 1 350 MW ultra-supercritical double reheat unit

schemes of four different steam turbine types were built to carry out simulation and calculations.The effects of exhausting outlet number

single-and doubleshaft arrangement(cross-compound or tandem-compound)and shaft speed selection on the unit's efficiency and economy were analyzed.The results show that

for the 1 350 MW ultra-supercritical double-reheat condensing unit

a tandem-compound 4-flow steam turbine with a primary rotor portion running at 3 000 rpm and a secondary rotor portion running at 1 500 rpm is the best scheme

the plant net efficiency can reach up to 46.01%.Then the second choice is the scheme of a cross-compound 6-flow steam turbine with rotor portion running at full-speed.Due to the technical limitation and investment economic weakness

it is better not adopt the scheme of a cross-compound 4-flow steam turbine with rotor portion running at full speed and the scheme of a tandem-compound 6-flow steam turbine with a primary rotor portion running at3000 rpm and a secondary rotor portion running at 1 500 rpm.

关键词

Keywords

references

Views

467

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Thermal economic analysis on an ultra supercritical unit with second reheat cycle

Control and optimization of water/coal ratio for an ultra supercritical 1 000 MW unit

Computational analysis on hydrodynamic characteristics and flow instability of an ultra supercritical 1 000 MW double-reheat unit boiler

ADAPTABILITY OF 3 000 t/h ULTRA SUPERCRITICAL BOILER FOR MIX BURNING WITH LOW HEAT VALUE COAL

CONTROL STRATEGY OF PRIMARY FREQUENCY REGULATION AND ITS OPTIMIZATION FOR 2×600 MW ULTRA SUPERCRITICAL UNITS IN HEYUAN POWER PLANT

Related Author

GU Yaxiu

WANG Shengpeng

YANG Shoumin

ZHU Baotian

ZHAO Zhidan

WANG Haitao

ZHANG Zhi

WANG Xiaoyong

Related Institution

School of Environmental Science and Engineering, Chang'an University

Xi'an Thermal Power Research Institute Co., Ltd

Liaoning Huadian Tieling Power Generation Co., Ltd

State Key Laboratory of Multiphase Flow for Power Engineering, Xi'an Jiaotong University

State Key Laboratory of Efficient and Clean Coal fired Power Plant Boiler of Harbin Boiler Works Co., Ltd

AI问答

⁰