Numerical modeling of corona electric field characteristics and electrode configuration optimization for a wet electrostatic precipitator

MA Xiuyuan; SHEN Zhiyong; LU Xiaocheng

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Numerical modeling of corona electric field characteristics and electrode configuration optimization for a wet electrostatic precipitator

更新时间：2025-09-28

- Numerical modeling of corona electric field characteristics and electrode configuration optimization for a wet electrostatic precipitator
- Thermal Power Generation Vol. 45, Issue 6, Pages: 74-80(2016)
- 作者机构：
  
  国电环境保护研究院
- 作者简介：
- 基金信息：
- DOI：
  CLC： X701.2
- Published：2016
- 稿件说明：
移动端阅览
MA Xiuyuan, SHEN Zhiyong, LU Xiaocheng. Numerical modeling of corona electric field characteristics and electrode configuration optimization for a wet electrostatic precipitator[J]. Thermal power generation, 2016, 45(6): 74-80.
DOI：

MA Xiuyuan, SHEN Zhiyong, LU Xiaocheng. Numerical modeling of corona electric field characteristics and electrode configuration optimization for a wet electrostatic precipitator[J]. Thermal power generation, 2016, 45(6): 74-80. DOI：

摘要

电极配置会影响湿式静电除尘器污染物脱除效率

对此

采用有限元法对湿式静电除尘器不同电极配置的空间电场进行数值模拟

分析了放电极针形、同极间距和供电电压对电晕区和收尘极附近电场特性和污染物脱除效率的影响。结果表明:放电极针形的顶部越平滑

收尘区的平均电场强度越大

且电场强度相对标准偏差越小

越有利于增强湿式静电除尘器对污染物的脱除效果

放电极最佳针形为平头;考虑运行电耗

放电极同极间距在340~380mm

供电电压为45~55kV时

湿式静电除尘器对污染物的脱除效果最佳。

Abstract

Electrode configuration has a certain influence on pollutants removal efficiency of the wet electrostatic precipitator(WESP).This paper applies the finite element method to study the electric field with different electrode configurations.The effects of discharge electrode form

electrode distance and supply voltage on the electric field characteristics in the corona area and near the collecting plate and that on the pollutants removal efficiency of the WESP were investigated.The results show that

the average electric field strength in the dust collecting area is greater and the relative standard deviation is smaller when the top of the discharge electrode needle is more smooth

which could improve the pollutants removal efficiency of the WESP.Flat top is the best type for discharge electrode needle.It is suggested that the electrode distance be from 340 mm to 380 mm and the supply voltage be from 45 kV to 55 kV.Under these conditions

the pollutants removal efficiency of the WESP is the highest.

关键词

Keywords

references

Views

186

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

ANALYSIS OF STRUCTURAL STABILITY FOR LARGE DIAMETER EXHAUST STEAM PIPING OF DIRECT AIR-COOLING UNIT

Related Author

LI Guo-dong1

SHI Xiang-bin2

LIU Xue2

ZHOU Yun-shan2(1.Beijing University of Science and Technology

Related Institution

Beijing University of Science and Technology

China Huadian Engineering (Group) Co., Ltd

AI问答

⁰