Cold state test and numerical simulation for flue gas SCR denitration in thermal power units
|更新时间:2025-09-28
|
Cold state test and numerical simulation for flue gas SCR denitration in thermal power units
Thermal Power GenerationVol. 45, Issue 6, Pages: 81-87(2016)
作者机构:
南昌大学机电工程学院
作者简介:
基金信息:
DOI:
CLC:X773
Published:2016
稿件说明:
移动端阅览
YU Tingfang, LIU Ran. Cold state test and numerical simulation for flue gas SCR denitration in thermal power units[J]. Thermal power generation, 2016, 45(6): 81-87.
DOI:
YU Tingfang, LIU Ran. Cold state test and numerical simulation for flue gas SCR denitration in thermal power units[J]. Thermal power generation, 2016, 45(6): 81-87.DOI:
Cold state test and numerical simulation for flue gas SCR denitration in thermal power units
The SCR denitration system in a 660 MW coal-fired thermal power unit has several problems
like low denitrification efficiency
high ammonia consumption and over large ammonia escape rate.To solve this problem
aphysical fluid model for this SCR device was built with proportional scale of 1∶12
and the cold state test of flow field and concentration field were carried out.Moreover
by computational fluid dynamics software STAR-CCM+
numerical simulation was performed
and the structural parameters affecting the SCR denitration performance and the ammonia spray amount at each ammonia injector were optimized.The results show that
the numerical simulation results are in accordance with the cold state test results.The denitrification efficiency of the optimized SCR device was increased effectively.The ammonia escape rate was reduced to lower than 3mg/m3.The study can provide a reference for performance optimization and transformation for similar SCR systems.