Influencing factors of reducing gas in water wall area of a 600 MW unit boiler
|更新时间:2025-09-28
|
Influencing factors of reducing gas in water wall area of a 600 MW unit boiler
Thermal Power GenerationVol. 45, Issue 12, Pages: 95-102(2016)
作者机构:
西安热工研究院有限公司苏州分公司
作者简介:
基金信息:
DOI:
CLC:TM621.2
Published:2016
稿件说明:
移动端阅览
XUE Xiaolei, YU Shengjie, CHEN Min, et al. Influencing factors of reducing gas in water wall area of a 600 MW unit boiler[J]. Thermal power generation, 2016, 45(12): 95-102.
DOI:
XUE Xiaolei, YU Shengjie, CHEN Min, et al. Influencing factors of reducing gas in water wall area of a 600 MW unit boiler[J]. Thermal power generation, 2016, 45(12): 95-102.DOI:
Influencing factors of reducing gas in water wall area of a 600 MW unit boiler
Serious high temperature corrosion occurred on water wall area of a 600 MW unit boiler.To solve this problem
the effects of the related factors on reducing atmosphere
such as the operation oxygen content and air distribution methods
were investigated.The results show that
the concentration of reducing gas around the boiler water wall area was higher under normal operating mode with 600 MW load condition
of which the volume fraction of CO was about 10 000~30 000μL/L
and that of H_2 S was about 80~130μL/L.Compared with the high-load conditions
the concentration of reducing gas around the boiler water wall area decreased more significantly under low load conditions.With a decrease in air damper opening of over-fire air
the volume fraction of CO in water wall area of the boiler declined obviously.With an increase in the operation oxygen content
the concentration of reducing gas around the boiler water wall area decreased slightly.Compared with other operation modes of the mills
the overall concentration of reducing gas in the boiler wall area is low under conditions with intermediate mill outages.High sulfur content in the coal resulted in an obvious increase in volume fraction of H_2 S in boiler water wall area.It is recommended to burn low-sulfur coal.