Research of neighbor inter-connection on cold end system of thermal power units
|更新时间:2025-09-28
|
Research of neighbor inter-connection on cold end system of thermal power units
Thermal Power GenerationVol. 46, Issue 10, Pages: 88-93(2017)
作者机构:
1. 西安西热节能技术有限公司
2. 华能威海发电有限责任公司
作者简介:
基金信息:
DOI:
CLC:TM621
Published:2017
稿件说明:
移动端阅览
LYU Kai, SUN Peng, REN Lijun, et al. Research of neighbor inter-connection on cold end system of thermal power units[J]. Thermal power generation, 2017, 46(10): 88-93.
DOI:
LYU Kai, SUN Peng, REN Lijun, et al. Research of neighbor inter-connection on cold end system of thermal power units[J]. Thermal power generation, 2017, 46(10): 88-93.DOI:
Research of neighbor inter-connection on cold end system of thermal power units
并计算分析了邻机互联改造后机组额定负荷下的节能效果。结果表明:环境空气湿球温度22.5℃时湿冷机组背压下降0.9 k Pa;环境空气干球温度33℃时表凝式间接空冷机组背压下降9.57 k Pa;环境空气干球温度33℃时直接空冷机组背压下降5.55 k Pa。该结果可为火电机组降低背压、实现节能降耗提供参考。
Abstract
Neighbour inter-connection on cold end system for the operating units was carried out by setting corresponding pipes and valves
and then the cooling equipments of outage unit
such as natural ventilation cooling tower
air cooling tower and air cooling condenser
were fully utilized by the operating unit
therefore the cooling capacity was enhanced and the back-pressure decreased. Taking the three typical kinds of cold end system such as wet cooling system
indirect air-cooling system and direct air-cooling system for 600 MW units as the example
technical scheme for neighbour inter-connection on cold end system was summarized and the energy conservation effect of operating unit under rated load was obtained. The results show that
after the neighbour cold end system inter-connection
the unit back-pressure decreased by 0.9 k Pa at ambient air wet-bulb temperature of 22.5 ℃ for wet cooling system
by 9.57 k Pa at ambient air dry-bulb temperature of 33 ℃ for indirect air-cooling system
and by 5.55 k Pa at ambient air dry-bulb temperature of 33 ℃ for direct air-cooling system. The results can provide references for reducing back pressure and realizing energy saving for thermal power units.